[Click] e1000 netpoll

[Beyers Cronje]

Have a look at Jennifer and John Bicket's thread earlier today. Same issue.
Or use 5.x driver with Click 1.4.3

On 6/22/05, rchertov at purdue.edu <rchertov at purdue.edu> wrote:
> Quoting Beyers Cronje <bcronje at gmail.com>:
> 
> > Roman,
> >
> > The driver should run and install fine on 2.4.26, that's the version
> > I'm running. My guess is the driver does not support your specific
> > e1000 controller. Use lspci or pciscan to see what controller your
> > e1000 card has, look in e1000_hw (I think) to see if your controller
> > is supported.
> 
> Turned out that my board was not supported.
> 
> >
> > If not, get the latest CVS version of Click, there's an updated driver
> > in the drivers directory that should support your newer controller.
> 
> 
> I have acquired the latest CVS snapshot and reinstalled everything again.  I
> have installed the 5.x e1000 driver this time.  Now I get the following message.
> 
> "conf/udpcount.click:18: While initializing 'ToDevice at 6 :: ToDevice':
>  warning: not compiled for a Click kernel with transmit notification
>  warning: can't get dev transmit notification: not compiled for a Click kernel"
> I have only modified the interface specific information regarding the IP and the
> MAC.  I looked in the INSTALL but could not find anything relating to what has
> to be set to get rid of the warning.
> 
> 
> 
> Thanks in advance,
> 
> 
> Roman
>