[Click] e1000 netpoll

[rchertov at purdue.edu]

Quoting Beyers Cronje <bcronje at gmail.com>:

> Roman,
> 
> The driver should run and install fine on 2.4.26, that's the version
> I'm running. My guess is the driver does not support your specific
> e1000 controller. Use lspci or pciscan to see what controller your
> e1000 card has, look in e1000_hw (I think) to see if your controller
> is supported.

Turned out that my board was not supported.

> 
> If not, get the latest CVS version of Click, there's an updated driver
> in the drivers directory that should support your newer controller.


I have acquired the latest CVS snapshot and reinstalled everything again.  I
have installed the 5.x e1000 driver this time.  Now I get the following message.

"conf/udpcount.click:18: While initializing 'ToDevice at 6 :: ToDevice': 
 warning: not compiled for a Click kernel with transmit notification
 warning: can't get dev transmit notification: not compiled for a Click kernel"
I have only modified the interface specific information regarding the IP and the
MAC.  I looked in the INSTALL but could not find anything relating to what has
to be set to get rid of the warning.  



Thanks in advance,


Roman