click-align tool

[Susan Xu]

Hi Eddie,

I downloaded and installed click 1.2.4. My machine is Sun Sparc.
When I am in userlevel and type ./click ../conf/test.click, the message
is "bus error". I guess it may be due to the alignment problem
indicated in the INSTALL file. I went to tool/click-align, and type make,
then re-run configure using:

./configure --prefix=/eng/home/susan/test_click/click-1.2.4 
enable-tools=/eng/home/susan/test_click/click-1.2.4/tools/click-align/click-align

and re-do

 ./click ../conf/test.click

Still get bus error message.

Could you please tell me how to use the click-align tool in
configure.

Thanks,
Sincerely,
Susan


******************************************************
Susan Xu                  Voice: (613) 530-4692
SOC Engineer                fax: (613) 530-8104
Canadian Microelectronics Corporation (CMC)
Queen's University
210A Carruthers Halleddie
Kingston, ON Canada          e-mail: susan at cmc.ca
K7L 3N6                    Web Site: http://www.cmc.ca
******************************************************