[Click] click

[Juan Luis Baptiste]

If click-install doesn't show any output is mostly because the configuration was installed without problems. You can see if the 
configuration has been successfully loaded by doing "cat /proc/click/config" and see if the configuration is there. 
 
 
Cheers, 
 
Juan Luis 
 
----- Original Message ----- 
From: "#TIRUGOKARNAM SUBRAMANIAN ADITYA RAGHAV#" <tsaditya at pmail.ntu.edu.sg> 
Date: Tue, 19 Aug 2003 08:15:57 +0800 
To: kohler at icir.org 
Subject: [Click] click 
 
> Hi eddie, 
>   
> I have installed click.o successfully as a kernel module. I am trying to install a kernel configuration using 
click-install.Cick-install exits with 0 if the configuration if it successfully installed the configuration and 1 if there is some 
error. But when I install the kernel configuration i dont get any return values. As soon as i execute the command I just get the next 
prompt without any return values so I am not sure if it has installed correctly or there are some errors. How do I get around this 
problem?. 
>   
> Regards, 
> Aditya Raghav 
>   
> Graduate Student 
> Information Communication Institute of Singapore 
> Nanyang Technological University 
>  
> _______________________________________________ 
> click mailing list 
> click at amsterdam.lcs.mit.edu 
> https://amsterdam.lcs.mit.edu/mailman/listinfo/click 
 
 
 
-- 
------------------------------- 
Juan Luis Baptiste M. 
IBM Certified Linux Scholar 
Linux registered user #119248 
http://www.merlinux.org 
http://knetworkconf.sf.net 
 
"we're back to the times 
 when men were men and 
 wrote their own drivers" 
        Linus Torvalds 
------------------------------- 
-- 
______________________________________________
http://www.linuxmail.org/
Now with e-mail forwarding for only US$5.95/yr

Powered by Outblaze