IPv6 click router...

[Juan Luis Baptiste M.]

Hi again,

I'm trying to use click as an ipv6 router. I'm using the configuration file
ip601.click. I saw that it only uses one interface (eth0), so if I configure the
machines with the ipv6 addresses as the configuration file says, and pin6'em
between them, each one respong to the other one, so I can't test the ipv6
router.

How can I use it with two interfaces, so I'm sure that the machines are
connected to diffent ipv6 segments?

Thanks!
--
Juan Luis Baptiste M.
email: jbaptiste at merlinux.org
http://www.merlinux.org

------------------------------------------------------
Todas las noticias de Linux y el mundo Open Source las
encuentras en Merlinux - http://www.merlinux.org