In this assignment you'll increase the maximum size of an xv6 file. Currently xv6 files are limited to 140 sectors, or 71,680 bytes. This limit comes from the fact that an xv6 inode contains 12 "direct" block numbers and one "singly-indirect" block number, which refers to a block that holds up to 128 more block numbers, for a total of 12+128=140. You'll change the xv6 file system code to support a "doubly-indirect" block in each inode, containing 128 addresses of singly-indirect blocks, each of which can contain up to 128 addresses of data blocks. The result will be that a file will be able to consist of up to 16523 sectors (or about 8.5 megabytes).
Submit your solution before the beginning of the next lecture to the submission web site.
Please collaborate with others on these exercises.
Modify your Makefile's CPUS definition so that it reads:
CPUS := 1
And add -snapshot to the definition of QEMUOPTS:
QEMUOPTS = -hdb fs.img xv6.img -smp $(CPUS) -m 512 $(QEMUEXTRA) -snapshot
The above two steps speed up qemu tremendously when xv6 creates large files.
mkfs initializes the file system to have fewer than 1000 free data blocks, too few to show off the changes you'll make. Modify the code at the start of mkfs.c to read:
int nblocks = 20985; int nlog = LOGSIZE; int ninodes = 200; int size = 21029;
Download big.c into your xv6 directory, add it to the UPROGS list, start up xv6, and run big. It creates as big a file as xv6 will let it, and reports the resulting size. It should say 140 sectors.
The code that finds a file's data on disk is in bmap() in fs.c. Have a look at it and make sure you understand what it's doing. bmap() is called both when reading and writing a file. When writing, bmap() allocates new blocks as needed to hold file content, as well as allocating an indirect block if needed to hold block addresses.
bmap() deals with two kinds of block numbers. The bn argument is a "logical block" -- a block number relative to the start of the file. The block numbers in ip->addrs, and the argument to bread(), are disk block numbers. You can view bmap() as mapping a file's logical block numbers into disk block numbers.
You don't have to modify xv6 to handle deletion of files with doubly-indirect blocks.
If all goes well, big will now report that it can write 16523 sectors. It will take big a few dozen seconds to finish.
Make sure you understand bmap(). Write out a diagram of the relationships between ip->addrs, the indirect block, the doubly-indirect block and the singly-indirect blocks it points to, and data blocks. Make sure you understand why adding a doubly-indirect block increases the maximum file size by 16,384 blocks (really 16383, since you have to decrease the number of direct blocks by one).
Think about how you'll index the doubly-indirect block, and the indirect blocks it points to, with the logical block number.
If you change the definition of NDIRECT, you'll probably have to change the size of addrs in struct inode in file.h. Make sure that struct inode and struct dinode have the same number of elements in their addrs arrays.
If your file system gets into a bad state, perhaps by crashing, you may need to delete fs.img (do this from Unix, not xv6).
Don't forget to brelse() each block that you bread().
You should allocate indirect blocks and doubly-indirect blocks only as needed, like the original bmap().
Submit: your modified fs.c